Adaptec ICP5045BL Guide de l'utilisateur télécharger pdf (Page 100)

Appendix D: Using the Array Configuration Utility for DOS ● 100

ControllerID Keyword

ControllerID is an optional keyword to change the SCSI ID of the controller. Normally, the

SCSI controller is assigned SCSI ID 7 on each of its channels. You can specify any ID value

between 0 and 7.

Caution:

Do not change the SCSI ID of the controller unless directed to do so by ICP

Technical Support.

For example:

ControllerID=7

End Keyword

End is a required keyword, indicating the end of the block.

ACU Error Codes

When the ACU detects an error, it reports the error and exits immediately. If a log file is

specified, the ACU writes the error code to the log file. Otherwise, it displays the error code on

the screen.

The possible error messages returned by the ACU are listed in this table.

Code Description

0 ACU ran without changes—ACU exited with no errors (success) and no report is required.

1 No controller found.

2 Syntax or logical error in the script file—The ACU encountered an invalid command or

keyword in the specified script file.

3 Unable to open file.

4 Error in the command line parameters—You passed an invalid command-line switch to the

ACU. (See

Running the ACU Using Scripts

on page 94

for a list of valid command-line switches.)

5 Unable to read system configuration—The ACU was unable to get the configuration

information from the specified controller.

6 No drives detected.

7 Specified drive not found in system.

8 Specified array size too small—You specified an array size that is smaller than the

minimum size allowed for this array.

9 Specified array size too big—You specified an array size that is larger than the maximum

size allowed for this array.

10 Number of drives do not match the array type—The number of drives you selected is

invalid for the type of array specified.

11 Unable to initialize drive.

12 Error occurred while creating array.

13 Too many spare drives assigned—You attempted to assign more than the maximum

number of hot spares allowed for the specified array.

14 Insufficient memory to run the application.

15 Incorrect controller number.

16 Controller not responding.

17 Build/Verify/Clear failed.

18 Cannot use drives on shared channel.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 134 135

Commentaires sur ces manuels

Pas de commentaire

Adaptec ICP5045BL Guide de l'utilisateur Page 100

Commentaires sur ces manuels

Produits connexes et manuels pour Contrôleurs périphériques Adaptec ICP5045BL