Adaptec 1045 Guide de l'utilisateur télécharger pdf (Page 34)

Chapter 7: Configuring the Controller Utility l34

● BBS Support - Controller

If the BBS Support is Controller, the system will boot from the Controller, and set the

disk that you wish to boot as Set Bootable. If you want to boot the system from one of

the devices connected, then select the option Device in the BBS Support.

● POST Banner Display - Enable

If the POST Banner Display is Enable, then every time the system boots a POST

message is displayed which show the controller information, the number of physical

devices that are connected to the system etc. To disable the POST messages, select the

option Disable.

● CTRL-A Message Display - Enable

If the CTRL+A Message Display option is Enable, it will display the CTRL A message

during the POST operation. Selecting the option Disable will stop the CTRL+A

message from being displayed during the POST operation.

● PD Display During POST - Enable

If the PD Display During POST option is Enable, it will display all the physical devices

that are connected to the system during the POST banner display. Selecting the option

Disable will stop the physical devices from being displayed during the POST Banner

Display.

● Bootable DVD/CD-ROM Support- Enable

If the Bootable DVD/CD-ROM Support option is Enable, it will boot from either

DVD/CD-ROM. Selecting the option Disable will not boot from DVD/CD-ROM.

Note:

To load the default settings, press <F6>.

Viewing the PHY Configuration

Use the arrow keys to select Configuration Utility and press <Enter> to access the PHY

Configuration.

You can set the SAS address for each of the 4 PHYs separately. Use the arrow keys to select the

required values and then <Enter> to confirm the changes.

Note:

To load the default settings, press <F6>.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 68 69

Pas de commentaire

Adaptec 1045 Guide de l'utilisateur Page 34